UBIQUITI UniFi® Access Elevator Starter Kit - UA-SK-Elevator

UA-Hub-Elevator
Mechanical

Dimensions

129.3 x 244.7 x 33.6 mm (5.1 x 9.6 x 1.3")

Weight

537 g (1.2 lb)

Enclosure material

Polycarbonate

Mounting material

Polycarbonate

Hardware

Networking interface

(4) 10/100/1000 Base-T

Management interface

(1) 10/100/1000 Base-T

Power method

PoE++

Max. power consumption

7W (Without PoE output)

PoE input

(1) PoE++, 50V DC, 1.2A

PoE output

PoE passthrough, (4) PoE, 50V DC, total 42W

ESD/EMP protection

Air: ±8kV, contact: ±4kV

Digital input

(5) Car position
(6) Car status; Up/down/stop/full/door open/door close
(1) Emergency

Outputs

(18) Relays
Rating 30V DC/2A

LEDs

System: white/blue/red
Output relays: white

Buttons

(1) Factory-reset
Terminal blocks

Operating temperature

-10 to 40° C (14 to 104° F)

Operating humidity

5 to 95% noncondensing

Certifications

CE, FCC, IC

UACC-Extender-2Wire-Tx/Rx
Mechanical

Dimensions

40 x 105 x 25 mm (1.6 x 4.1 x 1")

Weight

PoE in: 77 g (2.7 oz)
PoE out: 79 g (2.8 oz)

Enclosure material

Polycarbonate

Mounting material

Polycarbonate

Hardware

Networking interface

(1) 10/100 MbE
(1) Homeplug AV

Management interface

(1) 10/100 MbE

Power method

PoE++

Max. power consumption

3W (Without PoE output)

PoE input

(1) PoE++, 50V DC, Max. 1.2A

PoE output

(1) PoE+, 48V DC, 0.72A

ESD/EMP protection

Air: ±8kV, contact: ±4kV

LED

White

Operating temperature

-10 to 40° C (14 to 104° F)

Operating humidity

5 to 95% noncondensing

Certifications

CE, FCC, IC

UA-G2
Mechanical

Dimensions

93 x 40 x 36.5 mm (3.7 x 1.6 x 1.4")

Weight

82 g (2.9 oz)

Enclosure material

Polycarbonate, glass

Mounting

In wall, gang box

Weatherproofing

IP55

Hardware

Networking interface

(1) 10/100 MbE RJ45 port

Connectivity

BLE 4.1

Power method

PoE
UL 294 Power-limited Class 2 PSU
UL 60950-1/62368-1 LPS/PS2 PSU

Supported voltage range

48V DC

Max. power consumption

5W

ESD/EMP protection

Air: ±15kV, contact: ±8kV

Sensors

Proximity sensor

Speaker

(1) 8 ohm, 0.7W

LEDs

R/G/B/W

Button

(1) Factory-reset

NFC frequency

13.56 MHz

NFC read range

< 30 mm

NFC standards

ISO 14443A, 14443B, 15693

NFC technology

NFC Tag 1,2,3,4,5
MIFARE Classic
MIFAREPlus
MIFARE Ultralight
MIFARE DESFire

Operating environment

Outdoor use

Operating temperature

-30 to 45° C (-22 to 113° F)

Operating humidity

5 to 90% noncondensing

Software information

The software version of a product can be checked at https://unifi.ui.com

UL 294 level

Destructive attack: Level I
Line security: Level I
Endurance: Level I
Standby power: Level I

UL 294 statement

Compliance with IEEE 802.3 specifications was not verified as part of UL 294.
The equipment is intended to comply with the section of the National Electrical Code, ANSI/NFPA 70, Article 725.121, Power Sources for Class 2 and Class 3 Circuits.

PoE cabling requirements

Cable 5e cabling is the minimum performance category recommended. The performance category utilized should match the transmission speed required at the installation site.
The minimal conductor gauge permitted to connect between the PSE or power injector and the PD shall be 26 AWG (0.13 mm2) for patch cords; 24 AWG (0.21 mm2) for horizontal or riser cable.

CAN/ULC-60839-11-1 Grade

Grade assignment: I

Certifications

CE, FCC, IC, UL 294, CAN/ULC-60839-11-1

Document number, and issue date and/or revision level

UA-G2/UA-G2-Black, V02

LED

System

Steady blue: Adopted/device is ready
Steady white: Pending adoption
Blinking white/blue: Upgrading firmware
Strobing red: Emergency lockdown

UA-Card
Mechanical

Dimensions

85.6 x 54 x 0.8 mm (3.4 x 2.1 x 0.03")

Weight

5 g (0.18 oz)

Format

ISO 7810 ID-1

NFC frequency

13.56 MHz

NFC technology

ISO/IEC 14443 Type A
MIFARE DESFire
UniFi Access Proprietary Security Protocol